Model: CA05FS

 

Operation

1. Insert a mouthpiece into the mouthpiece inlet.

2. Push the ON/OFF power switch that is located under the display window.

- The unit will show “Full display” firstly and “on” along with a welcome sound. And then it starts

countdown which will be taken about 15 ~ 35 seconds. This warm-up process prepares the sensor

and circuit for testing.

3. When you hear a beep sound & “ bLo ” display is on, please blow steadily into the

mouthpiece until you would hear the “Beep” sound again. Stop blowing.

- In this stage, if you don't blow within 20 seconds, it automatically turns off. Try to power on again.

4. After the circling line is on the display for 3 ~ 22 seconds, the test result will be

displayed for 20 seconds along with beep sound.

- If the test result is over 0.25mg/l / 0.50‰ (default setting) respectively, “WARN” signal (Red LED) will

light up along with “Alarm” sound.

- The result will be displayed for 20 seconds .(Result display along with “READY” or “WARN” LED on

for the first 15 seconds and LED off for another 5 seconds).

. If you push the power switch when the Green or Red LED is off, the unit goes back to countdown stage

for another test.

5. Finally, the unit will show “OFF” and turn off automatically along with a sound.

6. For the successive testing, try again from No.2 to No.4.

7. Space tests at least 2 minutes apart.

? After using, you can turn the device off by pressing the power switch for 2 sec.

Precautions

1. Allow at least 20 minutes after eating or drinking before testing.

Any type of alcohol remaining in the mouth of saliva may interfere with proper testing and

requires about 20 minutes to disperse. This includes alcohol-based mouthwash or similar

products.

2. Avoid testing under strong wind or in the closed room with contaminated air.

3. When the “ BAT ” signal is on the display, it is advisable to replace 1.5V Alkaline Batteries.

4. Do not blow cigarette smoke, food or liquid into the instrument because this may damage

the sensor.

5. Do not use this unit as a tool to determine whether you or anyone else should operate any

motor vehicle or machinery.

6. Keep it under 0 – 40 °C (32 – 104 °F). And this device is designed to be used in a temperature

range of 5 – 40 °C (41 – 104 °F). Keep and use the unit within the recommended

temperature range.

7. Correlation between breath alcohol content and blood alcohol concentration depends on many

variables, including environ­mental factors (such as air quality, wind, humidity, temperature,

etc.) and health conditions of the test subject.

8. In normal use, CA05FS requires re-calibration every 6 months or after 500 tests to obtain

accurate results. Discuss with local distributors for re-calibration.

9. You cannot use the results of this unit in court of law. The driver holds full responsibility for

driving under the influence of alcohol.

10. Do not use this device in conjunction with an ignition interlock device or while sitting in a

motor vehicle .

11. An individual's testing result can continue to increase or decrease over time, depending on

many factors. Obtaining a testing result reading at one time does not mean the testing result

reading will be the same even a few minutes later.

12. Do not let yourself or anyone else drink and drive. Always use a designated driver when you

or anyone else drinks alcohol.

Components
1 X CA05FS
3 X Mouthpieces (individually wrapped)
2 X AAA size Alkaline batteries
1 X Carrying Pouch
1 X Manual

Warranty: 1 Year Limited Warranty

Manufacturer warrants for 1 year the product to be free from defects in workmanship
or material (excluding calibration) in normal service from the date if purchase. Manufacturer’s obligation under the warranty is limited the replacing, adjusting, or repairing the unit if returned along with proof of purchase. This warranty is void if the unit has been tampered with or maliciously damaged.